New Document
 
 
 
 
 
 
 
 


  Process and waste water
   
  Water analysis has never been so flexible - the DiaMon
  With true Multi-Parameter analysis, one DiaMon can replace several older types of analyzer. 4 sample
streams and up to 8 parameters can be analyzed simultaneously with a single instrument.
  Complex measurements such as Total N and Total P are also available. DiaMon is ideal for applications varying from process optimization through to final effluent monitoring.
This low-maintenance analyzer has low reagent consumption and uses long-life components.

 
   
  Measurement and control in one system – the BlueBox
  The BlueBox is a versatile instrument which
sets new standards in on-line analysis and has
unparalleled capacity – up to 100 sensors and
actuators from different manufacturers can be
controlled by one unit, with comprehensive data
storage and transmission facilities. One BlueBox acts as the heart of a decentralized analysis network which can include parameters such as conductivity, oxygen, Redox, pH, temperature and turbidity. Each parameter can be set to the
required range and accuracy.
In addition to sensors, the BlueBox can also integrate
more complex analyzers such as the Monitor 90 S
into an analysis network, and can transmit the
results on demand by email, SMS, modem or via
the internet.
 
   
  Accurate and Reliable – the Monitor 90 S
  Easy to use and maintain, the Monitor 90 S is a versatile
on-line analyzer with over100 documented applications
which are easily adapted to specific analysis tasks.
Up to 7 different sample streams can be measured by
one instrument. The Monitor 90 S is widely used to measure hardness, chlorine, ammonia, nitrate, iron, aluminium and manganese. Self-diagnostics, automatic calibration and low reagent consumption result in long intervals between routine maintenance to give low operating costs and minimum down
time.
 
   
  BioMon avoid the well-known problems of high maintenance
in conventional TOC and COD analyzers.
  True on-line TOC analysis provides the advantages of accurate control for waste water treatment plants or chemical processes without the disadvantages of the toxic chemicals used for
COD analysis. A daily analysis chart provides the user with essential information. Long-term results going back over days, weeks or months are also available to enable optimum process control. A feature of the BioMon is the short analysis time, which allows analysis results to be used in processes running in under closed-loop control.
 
   
  Ultra modern technology - ISIS
(In-line Spectroscopic Immersion Sensor)
  This sensational unit is a full-range UV-visible spectrometer built into a probe which can be fully immersed in a tank, pipe or process stream and measures continuously, with high
stability and almost no maintenance. The wide range measurement of the complete spectrum from 200 - 385 nm or
190 - 720 nm coupled with powerful software opens up true multi-parameter analysis for substances such as nitrate, suspended solids, organics, DOC, COD, BTX and individual
compounds such as benzene and phenol. The probe is exceptionally easy to install and operate and offers enormous cost savings.
 
 
ฉ2007 IMI Corporation. All rights reserved  
9/333-4 Moo 8 Phaholyothin Rd., Anusawwaree, Bangkhen, Bangkok, 10220, Thailand